Multiple choice questions

By

Control systems:

1. Multiple choice questions- 1

2. Important Gate questions with solutions

Total bits covered: 96

Measurements and Instrumentation:


Total bits covered: 35


Power Systems:



Total bits covered: 90



Electrical Machines:



Total bits covered: 50


Electrical Circuits:



Total bits covered: 30



Electrical and Magnetic fields:


1. Multiple Choice questions -1

Total bits covered: 10



SI Units:

1. Multiple Choice questions-1

Total bits covered: 10



Comments

Ankith said…
I am glad to read this post, its an interesting one. I am always searching for quality posts and articles and this is what I found here, I hope you will be adding more in future. Thanks.. Energy Management Software
17 November 2019 at 22:30
Post a Comment

Popular posts from this blog

Multiple Choice Questions in Power Electronics - 1

By
  Important multiple choice questions from Power Electronics 1.       Which one of the following statements is not correct? a)       Power MOSFETs are so constructed as to avoid punch through. b)       In a power MOSFET, the channel length is relatively large and channel width is relatively small c)       Power MOSFETs do not experience any minority carrier storage d)       Power MOSFETs can be put in parallel to handle large currents 2.       Which one is most suitable power device for high frequency (>100 kHz) switching application? a)       Power MOSFET b)       BJT c)       Schottky diode d)       Microwave transistor 3.       A thyristor equivalent of thyratron tube is a)...
Read more

Multiple Choice Questions on Power System - 3

By
Important multiple choice questions on power system 1.        A line trap in carrier current relaying tuned to carrier frequency presents A)      High impedance to carrier frequency but low impedance to power frequency B)       Low impedance to both carrier and power frequency C)       High impedance to both carrier and power frequencies D)      Low impedance to carrier frequency and high impedance to power frequency 2.        The use of fast acting relays and circuit breakers for clearing a sudden short circuit on a transmission link between generator and the receiving end bus improves the transient stability of the machine because A)      Short circuit current becomes zero B)       Post-fault transfer impedance attains a value higher than that during the fault C)  ...
Read more

Multiple Choice Questions on Power Systems - 5

By
Important multiple choice questions on power systems 1.        Which one of the following statements is true? A)      Steady state stability limit is greater than transient state stability limit B)       Steady state stability limit is equal to transient state stability limit C)       Steady state stability limit is less than the transient stability limit D)      No generalisation can be made regarding the equality of otherwise of the steady state stability limit and transient stability limit 2.        If the integral control of a single area system, when  the system frequency error is reduced to zero A)      The integrator output and the speed changer position attains a constant value B)       The integrator output increases but the speed changer position also comes dow...
Read more